# Coordinates offset about X +5-10 after filament change **URL:** https://marlin.crc.id.au/forum/t/coordinates-offset-about-x-5-10-after-filament-change/887 **Category:** Firmware Builder **Created:** [7 May 2022 19:30 UTC](https://marlin.crc.id.au/forum/t/coordinates-offset-about-x-5-10-after-filament-change/887 "2022-05-07T19:30:05Z") **Posts on this page:** 1 **Showing post:** 6
### Author: ![CRCinAU](https://marlin.crc.id.au/forum/user_avatar/marlin.crc.id.au/crcinau/32/1337_2.png) [@CRCinAU](https://marlin.crc.id.au/forum/u/CRCinAU) #### Post date: [10 May 2022 04:44 UTC](https://marlin.crc.id.au/forum/t/coordinates-offset-about-x-5-10-after-filament-change/887/6 "2022-05-10T04:44:28Z")
Probably not. If it isn’t a hardware fault / mechanical fault, then make sure you do a PID calibration on your hotend to make sure its working as it should. I doubt that it would save the power loss details on a panic stop… --- _[View the full topic](https://marlin.crc.id.au/forum/t/coordinates-offset-about-x-5-10-after-filament-change/887)._