# CR10S S5 builder bug

**URL:** https://marlin.crc.id.au/forum/t/cr10s-s5-builder-bug/1614
**Category:** Firmware Builder
**Tags:** builder
**Created:** [21 March 2023 03:30 UTC](https://marlin.crc.id.au/forum/t/cr10s-s5-builder-bug/1614 "2023-03-21T03:30:54Z")
**Posts on this page:** 3
**Page:** 1

<div class="post-metadata">

### Author: ![dwho](https://marlin.crc.id.au/forum/letter_avatar_proxy/v4/letter/d/dec6dc/32.png) [@dwho](https://marlin.crc.id.au/forum/u/dwho)
#### Post date: [21 March 2023 03:30 UTC](https://marlin.crc.id.au/forum/t/cr10s-s5-builder-bug/1614/1 "2023-03-21T03:30:54Z")

</div>

hi  
the builder for the CR10S S5 will not compile just as it is  
thanks

---

<div class="post-metadata">

### Author: ![dwho](https://marlin.crc.id.au/forum/letter_avatar_proxy/v4/letter/d/dec6dc/32.png) [@dwho](https://marlin.crc.id.au/forum/u/dwho)
#### Post date: [21 March 2023 09:37 UTC](https://marlin.crc.id.au/forum/t/cr10s-s5-builder-bug/1614/2 "2023-03-21T09:37:23Z")

</div>

this is the error  
rror: static assertion failed: PREHEAT\_2\_TEMP\_HOTEND (250) must be less than HEATER\_0\_MAXTEMP (255) - 15.

---

<div class="post-metadata">

### Author: ![CRCinAU](https://marlin.crc.id.au/forum/user_avatar/marlin.crc.id.au/crcinau/32/1337_2.png) [@CRCinAU](https://marlin.crc.id.au/forum/u/CRCinAU)
#### Post date: [21 March 2023 21:25 UTC](https://marlin.crc.id.au/forum/t/cr10s-s5-builder-bug/1614/3 "2023-03-21T21:25:06Z")

</div>

This is due to a tightening of sanity checking of configurations.

In essence, all max temperatures need to be below both the max temps, and the thermistor max temp specifications.

This shows that the preset temperature + 15c (overshoot detection) is higher than the max temperature that is set for the hotend.

You can either increase the max temp (assuming that keeps the thermistor within specifications) or reduce the preset 2 temperature from 250 to 240 or lower.