# Custom build of Creality Ender 3 + v4.2.7 has 1 direction XYZ Axis controls
**URL:** https://marlin.crc.id.au/forum/t/custom-build-of-creality-ender-3-v4-2-7-has-1-direction-xyz-axis-controls/1724
**Category:** Bug Reports
**Created:** [5 May 2023 17:57 UTC](https://marlin.crc.id.au/forum/t/custom-build-of-creality-ender-3-v4-2-7-has-1-direction-xyz-axis-controls/1724 "2023-05-05T17:57:46Z")
**Posts on this page:** 2
**Page:** 1
### Author:  [@iany-printing](https://marlin.crc.id.au/forum/u/iany-printing)
#### Post date: [5 May 2023 17:57 UTC](https://marlin.crc.id.au/forum/t/custom-build-of-creality-ender-3-v4-2-7-has-1-direction-xyz-axis-controls/1724/1 "2023-05-05T17:57:46Z")
I think there might be a bug in building an Ender 3 with v4.2.7 mainboard.
XYZ axis control only goes 1 direction.
I wanted to create a custom build that is the same as the daily build of
Ender 3 - v4.2.7 Board - BLTouch and just add Input Shaping support to test but the builder seems to have issues.
Am I the only one experiencing this?
Ian
---
### Author:  [@iany-printing](https://marlin.crc.id.au/forum/u/iany-printing)
#### Post date: [5 May 2023 22:09 UTC](https://marlin.crc.id.au/forum/t/custom-build-of-creality-ender-3-v4-2-7-has-1-direction-xyz-axis-controls/1724/2 "2023-05-05T22:09:39Z")
Looks like it was fixed at your end. A couple of hours later I tried it again and it worked fine.