# Daily build working fine, but lcd doesn't show varying bed heights during leveling process
**URL:** https://marlin.crc.id.au/forum/t/daily-build-working-fine-but-lcd-doesnt-show-varying-bed-heights-during-leveling-process/2720
**Category:** Firmware Builder
**Created:** [21 February 2026 20:11 UTC](https://marlin.crc.id.au/forum/t/daily-build-working-fine-but-lcd-doesnt-show-varying-bed-heights-during-leveling-process/2720 "2026-02-21T20:11:22Z")
**Posts on this page:** 2
**Page:** 1
### Author:  [@dillerseapickle](https://marlin.crc.id.au/forum/u/dillerseapickle)
#### Post date: [21 February 2026 20:11 UTC](https://marlin.crc.id.au/forum/t/daily-build-working-fine-but-lcd-doesnt-show-varying-bed-heights-during-leveling-process/2720/1 "2026-02-21T20:11:23Z")
hello everyone:
machine: ender 3 pro with 4.2.2 board, ret6 (512k) chip
probe: cr touch attached to touch probe port on board
firmware version: Ender3-v4.2.2-BLTouch-20260221.bin
an issue and a question:
Issue 1. when i go through bed leveling, either from lcd screen or prior to a print (using the startup gcode to trigger a bed level prior to each print with cura), as the machine is going through the bed leveling process, the lcd screen shows a constant z height. in other words, as the probe goes through each of the 25 points, the min and max z height is always the same
when i go to print, when i feel the z screws with my fingers, the machine is making minute adjustments so it is mechanically adjusting the z height during the print.
issue/question 2: the “babystep probe z” is the same as a babystep command, i.e. i minutely adjusts the nozzle height during the print, correct?
---
### Author:  [@dillerseapickle](https://marlin.crc.id.au/forum/u/dillerseapickle)
#### Post date: [28 February 2026 17:08 UTC](https://marlin.crc.id.au/forum/t/daily-build-working-fine-but-lcd-doesnt-show-varying-bed-heights-during-leveling-process/2720/2 "2026-02-28T17:08:33Z")
respectfully bumping