# Ender 3 Pro 4.7.2 with CR-Touch and filament run out

**URL:** https://marlin.crc.id.au/forum/t/ender-3-pro-4-7-2-with-cr-touch-and-filament-run-out/1812
**Category:** Firmware Builder
**Created:** [26 June 2023 02:19 UTC](https://marlin.crc.id.au/forum/t/ender-3-pro-4-7-2-with-cr-touch-and-filament-run-out/1812 "2023-06-26T02:19:39Z")
**Posts on this page:** 1
**Page:** 1

<div class="post-metadata">

### Author: ![kuruoshii](https://marlin.crc.id.au/forum/user_avatar/marlin.crc.id.au/kuruoshii/32/909_2.png) [@kuruoshii](https://marlin.crc.id.au/forum/u/kuruoshii)
#### Post date: [26 June 2023 02:19 UTC](https://marlin.crc.id.au/forum/t/ender-3-pro-4-7-2-with-cr-touch-and-filament-run-out/1812/1 "2023-06-26T02:19:39Z")

</div>

I am in need of a firmware for a 4.7.2 motherboard that supports bother the CR-Touch and the Creality Run out sensor. I have currently “Ender-3Pro\_HW4.2.7\_SW2.0.8.28\_CRTOUCH\_FILAMENT\_standard” from creality but every time the printer turns off it looses all the leveling settings and language defaults back to Chinese.

So i am needing a firmware that supports the following.

1. CR- Touch without extra board.
2. Filament run out
3. Resume printing after power outage
4. Filament change
5. bed leveling similar to the listed firmware.
6. memory card enabled

I tried to use the build your feature on this site but i think the home x and y are different than a normal ender 3. Also i didnt know what to do for the steppers.

Any Help would be very much appreciated.