# Ender 3 Pro firmware with Manual Mesh Bed Leveling

**URL:** https://marlin.crc.id.au/forum/t/ender-3-pro-firmware-with-manual-mesh-bed-leveling/744
**Category:** General Discussion
**Created:** [13 March 2022 17:14 UTC](https://marlin.crc.id.au/forum/t/ender-3-pro-firmware-with-manual-mesh-bed-leveling/744 "2022-03-13T17:14:26Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![cfrank01](https://marlin.crc.id.au/forum/letter_avatar_proxy/v4/letter/c/9fc348/32.png) [@cfrank01](https://marlin.crc.id.au/forum/u/cfrank01)
#### Post date: [13 March 2022 17:14 UTC](https://marlin.crc.id.au/forum/t/ender-3-pro-firmware-with-manual-mesh-bed-leveling/744/1 "2022-03-13T17:14:26Z")

</div>

I just used the firmware builder and added Manually Mesh Bed Leveling to it but all I see on my LCD screen is Level Bed with no sub-options to actually do anything. Did I miss something?

---

<div class="post-metadata">

### Author: ![JGonzo10](https://marlin.crc.id.au/forum/user_avatar/marlin.crc.id.au/jgonzo10/32/484_2.png) [@JGonzo10](https://marlin.crc.id.au/forum/u/JGonzo10)
#### Post date: [9 June 2022 03:42 UTC](https://marlin.crc.id.au/forum/t/ender-3-pro-firmware-with-manual-mesh-bed-leveling/744/2 "2022-06-09T03:42:32Z")

</div>

I built a my firmware for E3P 4.27 w/CR Touch. I just did the same thing and added the Manually Mesh and could not find the menu option for it. Is this a glitch in the firmware generator or is into supported by this board. Other firmwares I’ve tried had manual tramming options available. Any luck on your end?