# Ender 3 SKR 3 Mini E3 V3 problems with Jerk and som other minor issues **URL:** https://marlin.crc.id.au/forum/t/ender-3-skr-3-mini-e3-v3-problems-with-jerk-and-som-other-minor-issues/1892 **Category:** Firmware Builder **Created:** [16 September 2023 11:48 UTC](https://marlin.crc.id.au/forum/t/ender-3-skr-3-mini-e3-v3-problems-with-jerk-and-som-other-minor-issues/1892 "2023-09-16T11:48:51Z") **Posts on this page:** 1 **Page:** 1
### Author: ![Suliso](https://marlin.crc.id.au/forum/user_avatar/marlin.crc.id.au/suliso/32/977_2.png) [@Suliso](https://marlin.crc.id.au/forum/u/Suliso) #### Post date: [16 September 2023 11:48 UTC](https://marlin.crc.id.au/forum/t/ender-3-skr-3-mini-e3-v3-problems-with-jerk-and-som-other-minor-issues/1892/1 "2023-09-16T11:48:51Z")
At the start of the year I used the builder to make a firmware with the builder. Which worked fine and I was/am happy with it. I really like how easy it was to build a firmware. Lately I got problem with ringing and wanted to check out “Input Shaping”. Loaded my old profile into the builder and just added Input shaping, error… after some search I found a parameter in PID Temperatur had changed to BANG something something, changed it back to 255 and it worked. After installing the firmware more problems. - Sound from button press is muffled (some may like it some don’t, I got used to the loud beep) - Bed Leveling takes longer due to the Z axis moving up an additional 6 mm after a probe. The upward motion is not the problem but it moves the 6mm slow down again. My start gvode always makes a new mesh so this will increase the time of a print. - Jerk settings are not changed at least E-Jerk is 15.00 on the printer is set to 5.0 in the builder - My Z Jerk was set to 0.39 in the old build. If I set it to 0.39 in the new builder it is set to 0 on the printer and I can only change it by full numbers so to 1.00 - Font changes when editing a menu point (taller and slimmer) I am not a fan but I think this is one of the points that is not really important. I do understand some things change but at some of the things I am unsure if they are intended or a bug. Atm I went back to my old build wich I luckily still have on my computer.