# Homing not complete

**URL:** <https://marlin.crc.id.au/forum/t/homing-not-complete/2289>\
**Category:** Support\
**Created:** [29 September 2024 23:13 UTC](https://marlin.crc.id.au/forum/t/homing-not-complete/2289 "2024-09-29T23:13:12Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Zenus](https://marlin.crc.id.au/forum/letter_avatar_proxy/v4/letter/z/858c86/32.png) [@Zenus](https://marlin.crc.id.au/forum/u/Zenus)\
**Post date:** [29 September 2024 23:13 UTC](https://marlin.crc.id.au/forum/t/homing-not-complete/2289/1 "2024-09-29T23:13:12Z")

</div>

Anet A8, Marlin 2.1.2.4, Cura–Homing all, the Y axis won’t move to the limit switch. What to do?

---

<div class="post-metadata">

**Author:** ![CRCinAU](https://marlin.crc.id.au/forum/user_avatar/marlin.crc.id.au/crcinau/32/1337_2.png) [@CRCinAU](https://marlin.crc.id.au/forum/u/CRCinAU)\
**Post date:** [30 September 2024 01:48 UTC](https://marlin.crc.id.au/forum/t/homing-not-complete/2289/2 "2024-09-30T01:48:53Z")

</div>

This board is for support for firmware from this site specifically.

For general Marlin compilation questions, you’re better off on the Marlin Discord here: [Marlin Firmware - Discord Servers](https://discord.com/servers/marlin-firmware-461605380783472640)