# Inclusion of Ender 2 and 2 Pro in firmware builder and E2-PRO with CR/BL Touch in nightly downloads
**URL:** https://marlin.crc.id.au/forum/t/inclusion-of-ender-2-and-2-pro-in-firmware-builder-and-e2-pro-with-cr-bl-touch-in-nightly-downloads/862
**Category:** Firmware Builder
**Created:** [27 April 2022 00:25 UTC](https://marlin.crc.id.au/forum/t/inclusion-of-ender-2-and-2-pro-in-firmware-builder-and-e2-pro-with-cr-bl-touch-in-nightly-downloads/862 "2022-04-27T00:25:32Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@deball](https://marlin.crc.id.au/forum/u/deball)
#### Post date: [27 April 2022 00:25 UTC](https://marlin.crc.id.au/forum/t/inclusion-of-ender-2-and-2-pro-in-firmware-builder-and-e2-pro-with-cr-bl-touch-in-nightly-downloads/862/1 "2022-04-27T00:25:32Z")
Currently there is no support within the Firmware Builder for either the Ender2 or, more importantly the Ender2-PRO models.
My board revision is 4.2.3, using a similar profile for an E3 and editing details to those of the E2-PRO isn’t possible as change details such as stepper motor controller types isn’t possible.
On the compiled firmware there is no support for the E2-PRO with either a BL or CR Touch there are versions for seemingly every other model with z sensors, but not the E2-PRO.
I look forward to discovering the arrival of these configurations soon.
Many thanks,
David
---
### Author:  [@CRCinAU](https://marlin.crc.id.au/forum/u/CRCinAU)
#### Post date: [28 April 2022 04:39 UTC](https://marlin.crc.id.au/forum/t/inclusion-of-ender-2-and-2-pro-in-firmware-builder-and-e2-pro-with-cr-bl-touch-in-nightly-downloads/862/2 "2022-04-28T04:39:27Z")
The Ender 2 Pro is now available in the [Firmware Builder.](https://marlin.crc.id.au/builder/)
---
### Author:  [@deball](https://marlin.crc.id.au/forum/u/deball)
#### Post date: [28 April 2022 10:15 UTC](https://marlin.crc.id.au/forum/t/inclusion-of-ender-2-and-2-pro-in-firmware-builder-and-e2-pro-with-cr-bl-touch-in-nightly-downloads/862/3 "2022-04-28T10:15:12Z")
Many thanks for this.
Regards, DEB