# Runout Sensor Error with CR - 10 S5 Mega2560 board v2.2

**URL:** https://marlin.crc.id.au/forum/t/runout-sensor-error-with-cr-10-s5-mega2560-board-v2-2/850
**Category:** Firmware Builder
**Created:** [21 April 2022 04:55 UTC](https://marlin.crc.id.au/forum/t/runout-sensor-error-with-cr-10-s5-mega2560-board-v2-2/850 "2022-04-21T04:55:43Z")
**Posts on this page:** 1
**Showing post:** 19

<div class="post-metadata">

### Author: ![davidnormal](https://marlin.crc.id.au/forum/user_avatar/marlin.crc.id.au/davidnormal/32/419_2.png) [@davidnormal](https://marlin.crc.id.au/forum/u/davidnormal)
#### Post date: [25 April 2022 06:33 UTC](https://marlin.crc.id.au/forum/t/runout-sensor-error-with-cr-10-s5-mega2560-board-v2-2/850/19 "2022-04-25T06:33:24Z")

</div>

I believe I did start that last one from scratch, and not from a profile. I was about to try again and set it for LOW instead of high and see if that makes a difference.

Anyway, I’ll make a fresh build with default settings and try it again momentarily.

---

_[View the full topic](https://marlin.crc.id.au/forum/t/runout-sensor-error-with-cr-10-s5-mega2560-board-v2-2/850)._