Ender3-BLTouch-sdcard-<date>.hex
 - SD Card Support
 - Default probe offset for Creality BLTouch Mount - Change offset using M851 command and save to EEPROM with M500.
     Common offsets:
       - Petsfang Left - M851 X-48 Y-10 Z-2
       - Petsfang Right - M851 X+48 Y-2 Z-2
 - Adds G2 / G3 Arc support
 - Adds G10 / G11 Firmware based retraction (Use M207, M208, M209 to configure)
 - Slim Menus
 - Disables M503 to save space
Firmware VariantSizeLast Updated
Ender3-BLTouch-sdcard-20201117.hex 350102 bytes 2020-11-16 23:16:54 UTC Subscription Required
Ender3-BLTouch-sdcard-20201118.hex 350102 bytes 2020-11-17 23:16:51 UTC Subscription Required
Ender3-BLTouch-sdcard-20201119.hex 350102 bytes 2020-11-18 23:16:53 UTC Subscription Required
Ender3-BLTouch-sdcard-20201120.hex 350147 bytes 2020-11-19 23:16:59 UTC Subscription Required
Ender3-BLTouch-sdcard-20201121.hex 350147 bytes 2020-11-20 23:16:56 UTC Subscription Required
Ender3-BLTouch-sdcard-20201122.hex 350147 bytes 2020-11-21 23:16:49 UTC Subscription Required
Ender3-BLTouch-sdcard-20201123.hex 350147 bytes 2020-11-22 23:16:55 UTC Subscription Required
Ender3-BLTouch-sdcard-20201124.hex 350110 bytes 2020-11-23 23:16:55 UTC Subscription Required
Marlin is licensed under the GPLv3. Encourage others to comply with the license!