SKR-Mini-E3-v1.2-<date>.bin
 - Enabled CLASSIC_JERK
 - Adds G2 / G3 Arc support
 - Adds G10 / G11 Firmware based retraction (Use M207, M208, M209 to configure)
 - Adds M73 - Set Print Progress
 - Adds M125 - Park Head
 - Adds M412 - Filament Runout sensor on E0-STOP pin (Disable with M412 S0 if you don't have one, Check status with M119, Use the NO pins on your sensor)
 - Adds M600 - Filament Change (10mm extra purge)
 - Adds M701 / M702 - Filament load / upload
 - Adds M900 - Linear Advance - Use this tool to calibrate. Use this video as a guide.
 - Adds TMC Advanced monitoring (M122, M906, M911, M912)
 - Adds M913 - Enabled Hybrid Thresholds
 - FAN_SOFT_PWM enabled to remove fan coil whine of high flow fans

Firmware Variant	Size	Last Updated
SKR-Mini-E3-v1.2-20201117.bin	194920 bytes	2020-11-16 23:17:43 UTC	Subscription Required
SKR-Mini-E3-v1.2-20201118.bin	194920 bytes	2020-11-17 23:17:35 UTC	Subscription Required
SKR-Mini-E3-v1.2-20201119.bin	194960 bytes	2020-11-18 23:17:37 UTC	Subscription Required
SKR-Mini-E3-v1.2-20201120.bin	194968 bytes	2020-11-19 23:17:49 UTC	Subscription Required
SKR-Mini-E3-v1.2-20201121.bin	194968 bytes	2020-11-20 23:17:44 UTC	Subscription Required
SKR-Mini-E3-v1.2-20201122.bin	194968 bytes	2020-11-21 23:17:32 UTC	Subscription Required
SKR-Mini-E3-v1.2-20201123.bin	194976 bytes	2020-11-22 23:17:38 UTC	Subscription Required
SKR-Mini-E3-v1.2-20201124.bin	194944 bytes	2020-11-23 23:17:38 UTC	Subscription Required