SKR-Mini-E3-v2-BLTouch-<date>.bin
 - Default probe offset for Creality BLTouch Mount - Change offset using M851 command and save to EEPROM with M500.
 - High Speed BLTouch Profile
 - Enabled CLASSIC_JERK
 - Adds G2 / G3 Arc support
 - Adds G10 / G11 Firmware based retraction (Use M207, M208, M209 to configure)
 - Adds M73 - Set Print Progress
 - Adds M125 - Park Head
 - Adds M412 - Filament Runout sensor on E0-STOP pin (Disable with M412 S0 if you don't have one, Check status with M119, Use the NO pins on your sensor)
 - Adds M600 - Filament Change (10mm extra purge)
 - Adds M701 / M702 - Filament load / upload
 - Adds M900 - Linear Advance - Use this tool to calibrate. Use this video as a guide.
 - Adds TMC Advanced monitoring (M122, M906, M911, M912)
 - Adds M913 - Enabled Hybrid Thresholds
 - FAN_SOFT_PWM enabled to remove fan coil whine of high flow fans

Important notes for builds 20200718 onwards:
 - BLTouch connects to PROBE socket due to better resolution than the Z-STOP pin.
 - Use FAN0 for Part cooling fan
 - Use FAN1 for Hotend fan (will turn on above 50c, off below)
 - Wire the control board fan directly to the supply voltage (this is usually quieter than the hotend fan).
Firmware VariantSizeLast Updated
SKR-Mini-E3-v2-BLTouch-20201117.bin 206280 bytes 2020-11-16 23:19:20 UTC Subscription Required
SKR-Mini-E3-v2-BLTouch-20201118.bin 206280 bytes 2020-11-17 23:19:13 UTC Subscription Required
SKR-Mini-E3-v2-BLTouch-20201119.bin 206320 bytes 2020-11-18 23:19:15 UTC Subscription Required
SKR-Mini-E3-v2-BLTouch-20201120.bin 206328 bytes 2020-11-19 23:19:26 UTC Subscription Required
SKR-Mini-E3-v2-BLTouch-20201121.bin 206328 bytes 2020-11-20 23:19:22 UTC Subscription Required
SKR-Mini-E3-v2-BLTouch-20201122.bin 206328 bytes 2020-11-21 23:19:11 UTC Subscription Required
SKR-Mini-E3-v2-BLTouch-20201123.bin 206344 bytes 2020-11-22 23:19:15 UTC Subscription Required
SKR-Mini-E3-v2-BLTouch-20201124.bin 206304 bytes 2020-11-23 23:19:15 UTC Subscription Required