Ender3-V2-v4.2.7-Stock-<date>.bin - BETA FIRMWARE - FAQ and common problems
 - Stock marlin configuration for Ender 3 V2 with v4.2.7 mainboard
 - Adds G2 / G3 Arc support
 - Adds G10 / G11 Firmware based retraction (Use M207, M208, M209 to configure)
 - Adds M600 - Filament Change
 - Adds M603 - Set Filament Load / Unload length
 - Adds M701 - Load Filament
 - Adds M702 - Unload Filament
 - Enabled Advanced OK
 - Enabled CLASSIC_JERK
 - Enabled S_CURVE_ACCELERATION
 - Enabled Smart Filament Runout Sensor (Add M412 S0 in your Start G-Code if you do not have a filament sensor).

Known Issues:
 - Rotary Encoder on screen may not work correctly - Use 20210112 until this bug is fixed. Fixed 20210116 onwards.

Firmware Variant	Size	Last Updated
Ender3-v2-v4.2.7-Stock-20210114.bin	134824 bytes	2021-01-13 23:20:28 UTC	Subscription Required
Ender3-v2-v4.2.7-Stock-20210115.bin	134824 bytes	2021-01-14 23:20:31 UTC	Subscription Required
Ender3-v2-v4.2.7-Stock-20210116.bin	134920 bytes	2021-01-16 00:28:04 UTC	Subscription Required
Ender3-v2-v4.2.7-Stock-20210117.bin	134920 bytes	2021-01-16 23:20:27 UTC	Subscription Required
Ender3-v2-v4.2.7-Stock-20210118.bin	134920 bytes	2021-01-17 23:20:27 UTC	Subscription Required
Ender3-v2-v4.2.7-Stock-20210119.bin	134920 bytes	2021-01-18 23:20:27 UTC	Subscription Required
Ender3-v2-v4.2.7-Stock-20210120.bin	134912 bytes	2021-01-19 23:20:29 UTC	Subscription Required
Ender3-v2-v4.2.7-Stock-20210121.bin	134920 bytes	2021-01-20 23:20:31 UTC	Subscription Required