I have used the firmware builder to create a working version including cr-sprite-pro, bed leveling and runout sensor. But after a good print and then I do a filament change, when I run a “Auto Home” function the system either finds the bed in mid air or crashes the nozzle through the magnetic bed down to damaging the plate and grinds the z axis. Also after powering down and back on after a print has completed, I am prompted with Resume Print or End print every time. Is there a known issue with this behavior? I am using the 4.4.2 board and the right choice for that in the builder. It is a modified Ender 3 which has altered to auto bed leveling with CR-touch, CR-Sprite-Pro and original CR-Filament sensor. BL-touch wired the same and both tested work to stop print if it runs out with the exceptions listed above. Any help as to the cause would be much appreciated. I did try with a smart sensor for movement and out switch but it did not work due to configuration of Marlin ← I compiled it elsewhere. (obviously this firmware builder does not have the configs available to do that so I couldn’t try it with this site). I was using the main FIL-SENS 3 pin and the Z axis +input for the movement portion of the sensor. Still there was no luck compiling for it and I knew what ports because I had used the diagram schematics for the board and sensor etc… I have abandoned trying to use a movement sensor since the original does work with this builder. But these other issues still cause a problem I would like to solve. Thanks anyone who knows a possible solution in advance!