Can you add the Micro Swiss NG to available hot ends for CR10 V3 with BL Touch?
fyi, with the CR10 V3, the BL Touch is mounted on the stock mount - right side of print head and behind the right-side fan. This changes the X/Y offset.
I’ve added them to both of my CR10v3s and set the offset accordingly. The CRTouch works fine. I did get a bad SKK board where the 5v rail was defective which took awhile to resolve and replace. Everything works fine now.
Once in the firmware source code version the Z motion was set backwards; fortunately I saw and corrected this without much of an issue.
Allow yourself time to familiarize yourself with the settings in the configuration file. It is well laid out and documented but is a firehose of information. In particular comment what you change, so if you need to update the code, you remember what you did.