Custom build of Creality Ender 3 + v4.2.7 has 1 direction XYZ Axis controls

Marlin Firmware Service Bug Reports
1

I think there might be a bug in building an Ender 3 with v4.2.7 mainboard.
XYZ axis control only goes 1 direction.
I wanted to create a custom build that is the same as the daily build of
Ender 3 - v4.2.7 Board - BLTouch and just add Input Shaping support to test but the builder seems to have issues.
Am I the only one experiencing this?
Ian

2

Looks like it was fixed at your end. A couple of hours later I tried it again and it worked fine.