First time Marlin Firmware Service user here, I noticed that when printing a flow test, the print came out great but has this salmon skin like effect that runs diagonally instead of vertically or horizontally like most salmon skin issues. I saw a reddit post that exemplified my issue perfectly (left cube (https://www.reddit.com/r/FixMyPrint/comments/nns1hn/bad_salmon_skin_on_ender_3_pro/)) but the replies say that the issue is caused by linear advance and stealth chop when used together, while I do not have stealth chop enabled (prusaslicer). What other causes could there be? (I assume that the marlin firmware I am using uses linear advance)