Do the Daily Builds Include Power loss Recovery?

Just curious, its getting the time of year that winter storms cause power outages ( Happened once already halfway through a small print ) and I cant get power loss recovery to show up on the screen??

Running Ender 3 Pro 4.2.7 board, BL touch

Thanks

I don’t normally enable power loss recovery. Most boards only support saving these files to an SD Card, which given the file is rewritten with every Z line of print, it wears a lot of SD Cards our really quickly giving you a dead SD card, and eventually corrupt files to print.

If you wish to enable it however, you could build a custom firmware via the Builder with it enabled.