G1 X0 Y0 Z15 F500
nozzle is not in line with the bed at x0y0
how is this corrected? through g-code or firmware build?
Are you using the stock hotend? or have you changed the hotend for something else?
same hot end, did change to “direct drive” mount.
the nozzle ends up being 5mm off the front of the bed,
11 mm from where it should technically be on the buildplate
Figured it out. I was able to use M206 to shift the X0,Y0 over to where I needed to get it at.
M206
Hopefully this helps point others in the right direction.
1 Like