I have had my ender 3 pro for 2 years. I finally decided to install my BLTOUCH 3.1 a couple days ago. I installed the BTT firmware and everything works fine, except getting the extruder close enough to the surface. I have spent hours researching and watching videos with no luck. I downloaded the pre-built .bin file here and will attempt it tomorrow but am assuming I will have the same issue. For whatever reason, I cannot figure out how to resolve that. Any help would be greatly appreciated!
Run through the Z-Offset Wizard when you’ve got it all installed.
Thank you so much! that took care of it. I had to use the marlin 2.0 bugfix firmware but got it going.