Ender 3 V1 with CR Touch Firmware issues

Marlin Firmware Service Support
1

I just recently purchased this printer and trying to do all the upgrades but when When trying to install the CR Touch firmware for my Ender 3 (v1) 4.2.2 board (Firmware 2.0.1), it changes my main firmware backward to 2020 (Ver 1.1.2) when it boots when loading. I have flashed back to the current firmware (Ver 2.0.1) but it keeps happening every time I flash it again.

Mainboard Version: V4.2.2
Ender-3 Marlin2.0.1 - V1.1.2 - ALT(32bit)

CR Touch Version: Mainboard Version: V4.2.2
Ender-3 Pro Marlin2.0.1 - V1.1.2 - ALT(32bit)

What am I doing wrong?

2

I would like to add that I downloaded the Marlin firmware and then I updated with the CR touch firmware separately. Am I doing this wrong? Should I only be using the cr touch firmware from the others section for cr touch, or marlin with cr touch or marlin and then cr touch or just cr touch? Argh! I’ll be an engineer by the time k done I’ll tell you what!