Ender 3 V2 - 4.2.7 - Sprite Pro - CR Touch - Dual Z

Can’t find a firmware anywhere that will work.
Any ideas?

Go to “Nic’s 3D printer firmware” group on face book,
Join group
Under files section you will find a pre compiled firmware for what you need.
I’m running the same setup x3, printing abs and nylon daily!!

Thank you.
Waiting to be accepted into the group.

Is it OK if I reach out to you if I have questions?

Hello there. How are you guys? I’m trying to use all my bed space after installing the Sprite + Cr touch + dualz z on my ender 3 pro (4.2.7). Seems that the printer can’t reach the whole Y axis print space. (Something around 20 mm less space used). I think that is a firmware problem. I don’t know how to compile my own firmware. This firmware you guys are using is working fine? can you guys use the whole print area? Thanks in advance.

This can happen because of physical limitations with the changed position of the hotend.

Everything has to move within a set envelope - and moving one component means that it can’t always reach everywhere anymore.

You might find that you can no longer hit the far right hand side of the bed now - but you can reach beyond the bed on the left side.