I am running an Ender 3 v2 with 4.2.2 board and the nightly build firmware. I have installed an ender runout sensor. In the firmware I check the box for runout sensor. When running a test print I cannot get past the nozzle load line without the sensor repeatedly ejecting the filament and asking for confirmation the filament has been reloaded. The filament then loads and once again ejects it. Any suggestions?
If its a microswitch based one, make sure you turn off the motion option…
I don’t know how to do this. I am running Ender3-V2-BLTouch-20220408 and don’t see the motion option. I have tried updating my firmware but always get a screen that says Creality and Ender 3 v2 ready but its frozen there.