Hi-
I am working on a print and my printer shuts off with “G2/G3 bad parameters” error. When I go to terminal in Octoprint and type in G2 to check in Arc Support is enabled, it goes to error (screenshot)
Can this be added to the builder to be enabled?
ARCs should be enabled on everything built - do you have a build ID from the builder I could check out?
OK thats what I was assuming as well, but thought I would post. I just built a new firmware (5f796b22) to test. The current one on my machines in many months old.
Thank you
I just built another firmware (build ID: 30a601aa). went to terminal and hit G2 and same thing…
Ok - this isn’t a build issue… I can see in that build that ARC_SUPPORT is enabled - however, the G2 command actually needs parameters! You can’t just use G2 by itself.
Does it move if you try:
G2 I20 J20
From the ARC Documentation, that should:
Move in a complete clockwise circle with the center offset from the current position by [20, 20].