Newbie again.. performing an upgrade

General Discussion
1

Ok, I’ve done one upgrade previously (Ender 3 Pro 8-bit) but I used Arduino to add a bootloader and then the Arduino IDE to update the firmware…seems pertty complex…

Do the bin files that I download from the firmware service make this simpler ?
What is the easiest way to perform an upgrade
(I don’t see any instructions here anywhere)

thanks, Scott

2

Hi, is it the same board you flashed the boot loader on to? Oops I’m a bit late

1 Like
3

Your contribution can help others as well. It’s OK to be late.