Newbie question on Bilinear Bed Leveling

Marlin Firmware Service Firmware Builder
1

Hi everyone!

I’m having trouble setting up my custom firmware. I want a custom firmware so that I can enable Probe Offset Wizard, Where I’m getting stuck at is the question “Grid Size (X and Y)”. I’m not sure what to put in here. I have an Ender 3 Pro with a 235 x 235 bed.

Any suggestions?

Thanks!

zog

2

The grid size is how many points you want to probe across the bed.

A value of 5 would give you a 25 point grid (5 x 5). The higher the number, the smaller the distance between points.

3

Thanks for clarifying that for me @CRCinAU

4

This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.