Support Ender 3 With Direct Drive

Marlin Firmware Service Feature Requests
1

I have Ender 3 + 4.2.7 Board + CR Touch plus the cheap Creality direct drive upgrade - What I notice about the firmware is when levelling the CR Touch X Y starting points are off, I assume this is because it is set for the stock extruder. Is there any way to change this or offer a build for Ender 3 + 4.2.7 Board + CR Touch + Direct Drive?

Thanks

2

You’ll probably need to set the Probe Offsets. There’s a lot of YouTube videos on how to do this.

3

I don’t think it is probe offsets, I think it is these values:

PROBING_MARGIN_LEFT
PROBING_MARGIN_RIGHT
PROBING_MARGIN_FRONT
PROBING_MARGIN_BACK

Where can I find the G CODE for these?