Which firmware for an SKR E3 DIP 1.1?

Hi everyone!

I have an SKR E3 DIP V1.1 and I’m wondering if I can use a firmware from this site on this board.

Any suggestions?

Thanks!

zog

Right now, I don’t have the ability via the custom builder to set different stepper types - which has stopped me from being able to enable support for boards like this.

That feature is on the roadmap, but I don’t know when that will likely be available.

Hi @CRCinAU , thanks for the reply. I will have to build a firmware from Marlin source then.

For now, yes.

The problems I have with switchable steppers is that there are many, many different combinations to test to the point that it becomes almost impossible.

I don’t really want to go out and buy every combination of steppers and boards - so I have to figure out an “in theory” type of fix to be able to build for this type of hardware.

All the boards with fixed steppers are very much plug and play.