X/y offsets. after micro swiss

printer:

ender 3 pro
4.2.2
dual z. [works fine]
crtouch. [works great]
marlin 2.0.x
linear rail on x axis.
micro swiss direct drive/hot end [works as it should]

y issue is when i auto home it does its thing and when its done i am way off center.
44mm right of center
10mm forward of center.

so so i set home as left front corner? because if i try to set in center it says error too far

This is where you set your offset. In the config file of marlin

Don’t bother compiling it into the firmware - use M851 to adjust it - no firmware changes required.

1 Like