I have an Ender 3 v2 4.2.2 with CR touch installed. I just loaded the 10/24/21 nightly build and upgraded the firmware for the display as well. When I adjust the z offset in the wizard it doesn’t actually move the printhead. Is that expected behaviour or should making adjustments in the wizard move the head up or down?
I have the same exact configuration and the same exact problem. Also, I would love to be able to enable “Live” adjustments for “Move Axis” and “Z Offset” Both are active in another build that I have been using, but now I am kind of stuck using this build because I upgraded the DWIN_SET and can not get back to the original set so my display works. I had been using Releases · mriscoc/Marlin_Ender3v2 · GitHub build and it is excellent.