Not work BL probe in point from menu

Marlin Firmware Service Support
,
1

Hi all!

I’m use firmware Ender 3 V2 - BLTouch - Marlin Firmware Service
All work and good, but, brobe some points from menu nothing make.
For example, i’m press Prepare-> Bed Leveling → Front Left, all good i see all values, Bltouch make probe in this point.
if i press Prepare-> Bed Leveling → some other, priner nothing make and show z 0.00

Need make some settings?

2

See: Bed Tramming only left side on Ender 3 V2 4.2.2

3

I found that you dont set it in prepare. Rather go into control and advanced settings I think it is, Id have to look, and you will find a z probe offset wizard. Thats what you need to set and then store the settings.