On initial heatup, the Hotend takes a dip then finishes heating up. (PID has been run and saved)

[CRCinAU]

Check the PID Tuning part of the Ender 3 V2 FAQ - it applies here too.

Ender 3 V2 - Frequently Asked Questions

Table of Contents: Which firmware do I need for my printer? Flashing Firmware Recovering from a black screen after firmware update Help! My screen shows a picture of clouds! My screen is in Chinese, how do I switch it back to English? My Print Speed shows a crazy number and the printer goes nuts! How do I wire up a BLTouch? I’ve added a BLTouch, how do I set my Z-Offset? When I try to print, my printer just ejects all the filament! I want to use hardware retraction, what do I do? PID Tuning Wha…